Basic Functions; Idle State; Changing The Active Line; Dialing A Number - Snom 320 System User's Manual

S N O M U S E R ' S G U I D E

Basic Functions

Idle State

When the Snom 320 phone is not in use, it is said to be in "Idle State". In idle state, the phone shows:
1. The current date and time.
2. The current active line (up to 5 lines can be registered on a single phone)
3. The connection status of the active line. Typically this will show the telephone number.
If the active line is not registered, the active line shows NR instead of the number
4. Actions/functions mapped to the softkeys
5. Do Not Disturb (DND) status
6. Missed Calls
If there are missed calls recorded on your phone you may press the

Changing the Active Line

The Active Line is the telephone number which will be used when you place a call.
If the Snom 320 phone has multiple lines registered to it, a user can switch the current active line by
pressing the up or down arrow keys from the idle state. The phone display will show the current active
line only. If the line is not registered the phone will display NR.

Dialing a Number

There are two methods to begin a call from the idle state of the Snom 320. Either dial with the handset
resting in the cradle and then pick it up, or pick up the handset and then dial the number. In the latter
case, press to indicate that the number is complete and dialing can commence. The speakerphone
key can also be used instead of the
If the user has not pressed any keys for several seconds, the phone will automatically begin dialing the
number or partial number as it has been entered so far. This may result in an error message if the number
key to use the speakerphone.
8
key to clear the calls.