Ptz - IC Realtime Network Video Recorder User Manual

Parameter Function
Tour Display the selected video in local monitor window. When alarm
occurs, system can begin one-window tour for the activated record
channel. Please set the tour time in the local end.

PTZ

Here you can set PTZ movement when alarm occurs. Such as go to
activation preset x when there is an alarm.
The PTZ configuration events include preset, tour, and pattern.
Copy It is a shortcut menu button. You can copy current channel setup to
one or more (all) channels.
Save You can click save button after you complete setup for one channel,
or you can complete the whole setups and then click save button.
Refresh Click this button to get device latest configuration information.
7.3.2.6 PTZ
PTZ interface is shown as in
Please note, before operation please make sure you have set speed dome address and the NVR
and speed dome connection is OK.
Please refer to the following sheet for detailed information.
Parameter Function
You can select monitor channel from the dropdown list. .
Channel
Select the corresponding dome protocol.(such as PELCOD)
Protocol
Set corresponding dome address. Default value is 1. Please note your
Address
setup here shall comply with your dome address; otherwise you can
not control the speed dome.
Select the dome baud rate. Default setup is 9600.
Baud
Rate
F igure 7-34
3 3 0 H
Figure 7-34 PTZ
90