Upper Extremity Support Surface (Tray) - Convaid Cruiser User Manual

CONVAID USER'S GUIDE
Accessories

Upper Extremity Support Surface (Tray)

For all Cruiser and Scout: Tilt front of tray upward and insert hook under the bolt or the
plastic knob. Lower the tray so that the bent portion of the support rod locks over the
armrest tube. Fig. 64 Note: For Scout, raise armrest to a complete vertical position before
attaching tray.
For EZ Rider and Convertible: Attach one side of tray by hooking the black metal hook
around the push handle tube. Grasp the hook bar on the opposite side of tray, push inward
and hook around the corresponding push handle tube. Fig. 65
For Safari Tilt:
1. Depress spring button on underside of armrest until tray mount pops out. Fig. 66
2. Grasp tray mount and extend until locked into position. You may need to turn the tube
slightly to snap the spring button into the hole. Fig. 67
3. Holding tray in both hands, squeeze black handles and slide onto ends of tray mount.
Fig. 68
Note: For trays purchased after the chair, remove plastic cap at end of armrest
tube before inserting tray mount tube.
Fig.66
17
Fig.64
Fig.67
Fig.65
Fig.68