Table of Contents
Advertisement
Remote menu operation
An optional remote plug is available to enable operating
the camera mode and set buttons by remote control.
Confirm the plug is properly wired as indicated in the
figure and connect it to the rear panel Remote connector.
Do not connect anything to the unused Pins.
Remote plug(option)
External key switch connections for remote operation
Keep the distance between the remote plug and
external key switches to less than about 2 meters.
Disconnect the remote plug from the camera Remote
connector when not using the key switches.
NOTE
Be sure to switch off the camera power before
connecting or disconnecting the remote plug.
Pin
Signal
Not connected
1
Serial data input
2
Serial data output
3
Up key
4
Down key
5
Not connected
6
Not connected
7
Set key
8
Not connected
9
GND
10
Not connected
11
Not connected
12
Remote operation with RS-232C
Signals 2, 3 and 10 can be used for control by personal
computer. Consult dealer for retailed information.
Abbrev.
Remarks
N.C.
Do not connect
Tx
Connect to RS-232C
data terminal
Rx
Connect to RS-232C
data terminal
UP
Key switch connection
DOWN
Key switch connection
N.C.
Do not connect
N.C.
Do not connect
SET
Key switch connection
N.C.
Do not connect
GND
Connect to RS-232C
ground
N.C.
Do not connect
N.C.
Do not connect
33
Advertisement
Table of Contents
