8.10.3 Input balance for YPrPb signals
Remark on the input balance of a component video source
Before starting the Input Balance procedure, generate a signal with dominant white parts.
Input balance is also available for a component video source under following conditions:
•
A component video signal is present on the BNC's.
•
"Data on BNC's" is selected in the Source selection menu.
•
Pr/Y/Pb is selected in the Advanced menu of the corresponding image file.
The procedure is the same as for a data source except:
•
The white balance happens only on Green.
Adjust until bright spots appear in the image.
Image 8-43
•
The black balance happens on the three colors.
The PR and PB connector have to be removed from the input.
Adjust until noise appears in the image.
Image 8-44
8.11 AGC on Video
AGC
Automatic Gain Control: allows an automatic amplitude (gain) control of the incoming video signal
AGC is only for Video signals.
Enabling/disabling the AGC
1. Press MENU to activate the menu bar.
2. Press → to select the Image item.
R5976816 RLM R6+ PERFORMER 21/12/2005
8. Image Menu
85