First Time Installation - Strong PRIMA II User Manual

4. First Time Installation

After all the connections have been made properly, switch on your TV.
Make sure the receiver is connected to the mains and press Power to
switch the receiver on. If you are using the receiver for the first time,
a First Time Installation menu will be displayed to guide you through
the initial setup. Use the remote controller to finish the setup.
1. At the First time installation menu, select in first step your regional
settings, for next step press
2. Select then you're OSD Language, Time Zone and Antenna Power.
If you use an active antenna please select Antenna Power to ON.
Then select NEXT to proceed.
Note: Make sure to select the region you are located since the receiver will scan the
channels based on the bandwidth of the region you selected. If your region is not on
the list, you are recommended to conduct a manual search. Refer to
Search on page 16 for details.
on the remote control.
First Time Installation (1)
Region
England
Language English
GMT + 00:00
Time Zone
Antenna Power
OFF
BACK NEXT
7 7
Manual