Osd Setting - Strong SRT 5203 User Manual

GMT Usage:
GMT Offset:
Date/Time:
Time Display:
5.3.4 Timer Setting
In this menu you can set a programme timer or sleep timer.
Programme timer
Timer Number:
Timer Mode:
Timer Service:
Wake-up Channel:
Month/Date/Day:
Time:
Duration:
Auto Record:
Quitting the programme timer, a saving window appears, select Yes in the confirmation
window with tu and press OK to save or select No to cancel.
Sleep Timer
You can set the receiver to switch to Standby in 10, 30, 60, 90 and 120 min automatically.
Additionally there is shown the value of remaining time Remains: HH:MM

5.3.5 OSD Setting

This menu allows you to change settings for: Subtitle Display, OSD Transparency, and
Load Default OSD Setting.
Subtitle Display:
OSD Timeout:
OSD Transparency: To set the OSD transparency from Off ~ 50 %.
Load Default OSD Setting:
5.3.6 Parental Lock
This menu allows you to protect the installation menu, or channels with a password
and you can change the Password. If you want to enter the menu you will be asked to
10
This menu is used for usage of GMT.
The options are: Off / User Define / By Region
This menu is valid only when selected "User Define" in GMT
Usage menu. The GMT offset range is "-11:30 ~ +12:00",
increasing by half hours progressively.
"Date" and "Time" menus are valid only when selected "Off" in
GMT Usage menu. Press OK then numeric button to change the
date and time.
This menu allow to control whether the time is displayed on
screen or not. The options are: Off/On.
You can set 8 timers
Off/Once/Daily/Weekly/Monthly
TV Service/Radio Service
You can select a desired channel as wake-up channel.
Press pq buttons to select your desired month, date and day.
Press OK to input the time with the numeric buttons.
Press OK to input desired duration with the numeric buttons.
Use tu to adjust ON or OFF, depending if you want the timer to
activate recording via USB device.
To set the subtitle to DVB, Teletext or OFF.
To set the desired duration for banner display from 3 ~ 10 s.
To clear all OSD settings and reset to default value.
PART 1 • English