Table of Contents
Advertisement
TOUR Notes
Master Dimmer
Red, Green, Blue
White, and Amber
Color Selection
Color Macros
Strobe
Auto/Custom
Dimmer Speed
COLORado™ Range IP User Manual Rev. 06
These notes clarify the way the TOUR DMX personality works.
Channel 1 controls the intensity of the currently projected color.
When Channel 1 is at the highest position (100%) the intensity of the output is at its
maximum.
Channels 2 through 11 control the intensity ratio of each of the Red, Green, Blue, White,
and Amber LEDs in each module.
When these channels are at the highest position (100%), the intensity of each color is at
its maximum if SETTINGS > COLOR is OFF.
You can combine channels 2 through 11 to create over one trillion colors.
Channel 12 selects the required Color Macro.
Channel 12 has priority over channels 2 through 11.
Channel 1 controls the intensity of the Color Macro.
Channel 13 controls the strobe frequency (not the intensity) of channels 2 through 12.
Channel 13 can strobe channels 2 through 12 when not running macros, the individual
faders (R, G. B, W, and A) as well as channel 1 control the output intensity.
Channel 13 can strobe channel 12 when running macros, allowing channel 12 to select
the macro and channel 1 to control the output intensity.
Channel 14 selects the preset auto programs AUTO 01~10 or the custom programs
CUSTOM 01~10.
When activating the custom programs CUSTOM 01~10, it is possible to control the Step
Time and Fade Time using channels 2 and 3 respectively.
Channel 14 has priority over channels 2 through 13.
Channel 15 controls the speed at which each auto programs plays.
Channel 16 selects the dimmer mode and speed. Dimmer mode gives the user four
different options to simulate the dimming curve of an incandescent lighting product.
When DIMMER is set to OFF, the changes in the RGBWA and Master Dimmer faders
are linear. Otherwise, DIM1 is the fastest dimmer curve, while DIM4 is the slowest.
Operation
-13-
Advertisement
Table of Contents
