Mounting; Orientation; Rigging - Chauvet COLORado Range IP User Manual

Mounting

Orientation

Rigging

Procedure
Product Mounting
Diagram
COLORado™ Range IP User Manual Rev. 06
Before mounting this product, read and follow the safety recommendations indicated in the
Safety Notes section (page 2 of this manual).
Always mount this product in any safe position while making sure that there is adequate
room for ventilation, configuration, and maintenance.
The COLORado™ Range IP consists of a heavy-duty rigid steel frame which enables this
product to be hung overhead (using included omega brackets) or placed on the floor.
CHAUVET® recommends following the general guidelines below when mounting this
product.
 When selecting an installation location, consider ease of access to this product for
operation, programming adjustments, and routine maintenance.
 Make sure to mount this product away from any flammable material as indicated in the
Safety Notes section.
 If hanging this product, make sure that the location where you are mounting it can
support its weight. Please see the Technical Specifications section of this manual for
the weight requirement of this product.
The COLORado™ Range IP comes with omega brackets that attach to the bottom of the
product using ¼ turn locking screws to which you can attach clamps. You must supply your
own clamps and make sure that they are capable of supporting the weight of this product.
You must use two mounting points per unit. Alternatively, you can remove the omega
brackets and mount the product to the floor.
Clamps (not
included)
Floor Mounting
Omega Brackets
Safety Cable
(included)
Overhead Mounting
Setup
-7-