Cleaning & Sanitizing - Grindmaster Crathco MG235-2B Operation And Instruction Manual

Cleaning and Sanitizing Procedures
! Warning
Disconnect the unit from its power supply
prior to cleaning or sanitizing the unit. Failure to do so may
result in electric shock.
Daily Cleaning
For the machine to function properly, it is important that
the cleaning procedures be carried out daily, according
to the following instructions:
1.) Turn off the /
switches and empty the bowl of its remaining product; after draining the prod-
uct from the unit, you can fill the bowl with hot water (not boiling) to help melt
off any sugar deposits. Then drain the water prior to proceeding to step (2).
2.) Unplug the unit.
3) Pull out the mixing rod (E) by pushing it slightly backwards
to remove it from its position (see fig. Q on pg.8).
4.) Unscrew and remove the two knobs (F) then lower the bowl to
drain out any remaining product through the dispensing valve
(see fig. R).
5.) Remove and disassemble the dispensing valve:
• Remove the pin (G) as shown (see fig. S).
Then, remove the handle (B) sliding it from its seat.
• Simultaneously apply pressure to the two securing tabs (H) and
lift the dispensing valve (C) to pull it out of its position (see fig. T).
6.) Remove the bowl (L) by unscrewing the two knobs (F) and
pulling it downwards as shown in fig. U.
7.) Unscrew the securing bolt (M) clockwise. Pull off the auger (N)
and remove the shaft seal (O) and the bowl seal (P) (see fig. V).
8.) Remove the drain tray by lifting up on the front edge, while lowering the
rear edge, and then lift it off the unit (see fig. W).
9.) Thoroughly wash each part that has been removed in steps 1-8 and the base
(Q), as well as the freezing cylinder (R) with warm water and mild dish-
washing detergent. Rinse well with clear water and allow to air dry (see
fig. X). Avoid the use of abrasive cleaners which can damage the finish.
Do not put in dishwasher. Dishwasher may damage some parts such as
the clear plastic auger gears and top mixing bar. Reassemble with clean
hands.
G & MG Series Granita Machine
(G, fig. M) refrigeration and / (F, fig. M) freezing
(Figure R)
(Figure S)
(Figure T)
(Figure U)
(Figure V)
(Figure W)
(Figure X)
Page 9