Dispensing Product; Adjustments - Grindmaster Crathco MG235-2B Operation And Instruction Manual

Dispensing Product

To dispense the product, position the cup under the dispensing valve (C)
and lower the dispensing lever (B) (see fig. O).
!
Attention:
If the machine is turned off at night, with the bowls filled,
or just partially filled, a layer of solid ice may form on the surface due to the
natural separation of the unmixed (non-moving) product. In this case, before
turning the machine back on, remove the layer of superficial ice to prevent
damage to the mixing auger.

Adjustments

!
Attention:
To prevent the product from becoming too thick,
it is necessary to push left "Press To Select Function" and right
"Press To Select Function" keys to cold drink position or to refill
the bowl when the level of the granita inside the bowl is below the
minimum fill line.
Consistency Adjustment
1.) Unplug the machine.
2.) Be sure that product in bowl is within proper fill range.(Above the minimum
fill line)
3.) Remove merchandiser.
4.) Change the thickness of the product by turning the screw (D) on the back of
the bowl, as shown on fig. P. Turn the screw clockwise for thinner product or
counterclockwise for thicker product. The indicator gauge (D1), located on
the back of the bowl, shows the degree of adjustment (+/-). (+) = thicker,
(-) = thinner
Note: This (D1) is an indicator gauge only. To adjust consistency, turn screw
on top (D).
Page 8
(Figure P)
(Figure Q)
G & MG Series Granita Machine
(Figure O)