Vello Freewave User Manual page 7

SETTING THE SMART CODE
The FreeWave supports 16,000,000
possible radio channels. The units have
been synchronized at the factory, so
your system can work right out of the
box. However, to maximize signal quality
and range, it's best to use the Smart
Code technology to sense the "quiet"
frequencies in your environment and
re-synchronize on that channel.
Multiple receivers can be programmed
to respond to a single transmitter,
allowing you to trigger several cameras
with a single transmitter.
To synchronize the Transmitter
and Receiver(s):
1. Turn on the Receiver(s) by pressing
and holding the Set/Power button
until the left red LED comes on.
2. Set the Receiver(s) to Ready and the
Transmitter to Single/Bulb.
3. Press the Set/Power button on the
Receiver(s) ve times. The right LED
will begin blinking red.
4. Fully depress the shutter button on
the Transmitter. The right LED on the
Receiver(s) will blink and then turn off.
7
5. Your Smart Code is set and will
remain set to this code even after the
Receiver is turned off.
To test for synchronization, press the
shutter release button on the
Transmitter. If you press halfway, the
right LED on the Receiver will light
green. Pressing all the way will turn the
LED red. If you don't see this
con rmation, re-synchronize the units.