Vello Freewave User Manual page 13

SINGLE SHOTS | WIRED
The FreeWave Receiver can also be
used as a wired remote. With your
camera and receiver OFF, connect the
shutter release cable's miniplug end to
the Receiver and the other end to your
camera's shutter release jack. Power up
your camera. The Receiver does not
need to be on, but because the Receiver
does not need power in wired mode,
the LEDs will not light.
1. Turn on the Receiver by pressing and
holding the Set/Power button until
the left red LED comes on.
2. Set the Receiver to Ready.
3. Press the Receiver's shutter release
button halfway to wake or focus your
camera (if set to Auto Focus). The
con rmation LED will not display, so
be sure to manually focus or allow
the camera to Auto Focus without
con rmation.
4. Fully depress the shutter button on
the Receiver. The shutter will be
triggered.
Moving the Receiver switch to Hold
will also trigger the shutter.
13