Tripp Lite NetCommander B070-016-19-IP Owner's Manual page 26

29. Local Firmware Upgrade
Current Firmware Verification
After the physical connection is made, you need to install the Firmware
Upgrade Utility on the upgrade computer (the computer you just connected to
the KVM), and then check the current firmware version on your KVM to see
if it needs to be updated. To do this, follow the steps below.
1. On the upgrade computer, go to www.tripplite.com/support and download
the latest firmware for the B070-016-19-IP. Both the Firmware Upgrade
Utility and KVM/SIU Firmware Upgrade File will be downloaded together.
2. Run the Firmware Upgrade Utility to install it on the upgrade computer.
Follow the installation prompts to successfully install the utility.
3. When installation is complete, clicking the Finish button will automatically
open the Firmware Upgrade Utility with the main screen displayed.
201204110 93-2924.indd 26
(Continued)
4. To check the firmware version of the KVM, check the checkbox at the top
of the screen next to the text NetCommander IP Switch.
5. Click on the F/W Version button at the bottom center of the screen to pull
up a box that displays the current firmware versions. Note: There are three
firmware versions associated with the B070-016-19-IP KVM; Translator
F/W, Manager F/W and OSD F/W.
6. Compare the current firmware version numbers of the KVM with the firmware
version numbers you downloaded to see if your KVM needs to be upgraded.
7. If checking the current firmware version of the connected SIU(s), uncheck
the KVM checkbox at the top of the screen, and then check the checkboxes
next to each SIU that you wish to determine the firmware of.
8. When you have selected all the desired SIUs, click on the F/W Version
button at the bottom center of the screen to display their current firmware
version numbers.
9. Compare the current firmware version numbers of the SIU(s) with the
firmware version numbers you downloaded to see if you need to upgrade
your SIU(s) firmware.
26
8/2/2012 10:16:03 AM