Save; Reload; Device Reboot; Device Upgrade - Tripp Lite NetCommander B070-016-19-IP Owner's Manual

18. Save

To apply any configuration changes you make, you must click the Save button at the top of the screen. Certain changes, such as Device page and Security page
changes, require the KVM to be rebooted. When clicking the Save button after these types of changes, a prompt will appear to inform you that a reboot is
needed. Click Yes to continue with the changes and reboot, or No to cancel.

19. Reload

Click the Reload button at the top of the screen to restore the selected pages default values.

20. Device Reboot

Click the Device Reboot to reboot the KVM switch.

21. Device Upgrade

The B070-016-19-IP has two sets of firmware; one to control IP access and
another to control the KVM's Mainboard and OSD. This section of the Web
Configuration Interface allows you to update the KVM switches IP firmware.
The non-IP firmware is updated using the KVM OSD. (See Local Firmware
Upgrade section for details on updating the non-IP firmware)
1. Go to www.tripplite.com/support and find the available firmware upgrades
for the B070-016-19-IP, and save them on a computer not connected to the
KVM switch.
2. Log in to the Web Configuration Interface and click on the Device button.
The current IP firmware version is displayed in the center of this page.
3. Click the Browse button and navigate to and select the file you just
downloaded.
4. Once the new firmware upgrade file is selected, click the Start Upgrade
button. Upon completion, click the Device Reboot button to finish the
upgrade. Depending on the upgrade, the following settings may be erased:
User settings, server names and mouse/video adjustments. Network
Settings will remain intact.

22. Factory Restore

The Factory Restore function will reset all of the settings and accounts added
by administrators to the Web Configuration Interface. There is a check box
that allows you to leave the network settings unchanged, while resetting
everything else. If this box is not checked, performing a restore will clear the
network settings information.
Warning: Once reset, the data cannot be retrieved.
To restore factory settings
1. Click the Factory Restore button.
2. Check the box if you want to preserve Network settings.
3. Click Restore. Device settings are now restored to their defaults.
201204110 93-2924.indd 14
14
8/2/2012 10:15:56 AM