Muratec MFX-3550 User Manual page 184

Troubleshooting
Enter Again
File Format isNot
Supported
Fuser error
Group
NotAvailable
IP Conflict
This IP address
conflicts with
that of other
system
Jam bottom of
duplex
Jam in exit area
Jam inside
Machine
Jam top of
duplex
Junk Fax Error
Junk FaxJob
Cancelled
Line Busy
The line is
already engaged.
Try later
Line Error
The Fax Line has
a problem.
Try again
Mail Size Error
Mail exceeds
thanserver
support
Mail Size Error
One Page isToo
Large
Memory Full
Cancel | Start
Memory Full
Divide the Job
Memory Full
Fax memory is
full. Print or
Downloaded from http://downloadcenter.samsung.com/content/UM/200907/20090721152022250/EN/english/t... www.Manualslib.com
You entered an unavailable item.
The selected file format is not
supported.
There is a problem in the machine.
You have tried to select a group location
number where only a single location
number can be used, such as when
adding locations for a multiple send
operation.
The IP address is used elsewhere.
Paper has jammed during duplex
printing.
Paper has jammed in exit area.
Paper has jammed inside the machine.
Paper has jammed during duplex
printing.
The machine has received a fax from
which is registered as a junk fax.
The receiving fax machine did not
answer or the line is already engaged.
Your machine cannot connect with the
receiving fax machine or has lost
contact because of a problem with the
phone line.
The mail size is larger than the
supported size by SMTP server.
Single page data exceeds the configured
mail size.
The memory is full.
The memory is full.
The memory is full.
manuals search engine
Enter the correct item again.
Use the correct file format.
Turn the machine off and turn it on
again. If the problem persists, call
for service.
Use a speed dial number or dial
number manually using the
number keypad.
Check the IP address or obtain a
new IP address.
Clear the jam. (See
unit area
Clear the jam. (See
Clear the jam. (See
machine.)
Clear the jam. (See
unit area
The received fax data will be
deleted.Reconfirm junk fax setup.
(See Receiving.)
Try again after a few minutes.
Try again. If the problem persists,
wait an hour or so for the line to
clear again. Or, turn the ECM
mode on (See Sending.)
Divide your mail or reduce the
resolution.
Reduce the resolution and try
again.
Press the left/right arrow to
highlight Cancel or Start, then
press OK. If you select Cancel ,
the machine stops the fax job. If
you select Start, the machine only
sends scanned documents of the
fax job.
Split the transmission into more
than one operation.
Print or remove the received fax
data in the memory.
183
Page 12 of 27
In the duplex
.)
In exit area.)
Inside the
In the duplex
.)
8/4/2009