Muratec MFX-3550 User Manual page 12

Regulatory information
equipment on your telephone line should be less than five in order to assure proper service from the
telephone company. In some cases, a sum of five may not be usable on your line. If any of your
telephone equipment is not operating properly, you should immediately remove it from your telephone
line, as it may cause harm to the telephone network.
FCC Regulations state that changes or modifications to this equipment not expressly approved by
the manufacturer could void the user's authority to operate this equipment. In the event that
terminal equipment causes harm to the telephone network, the telephone company should notify
the customer that service may be stopped. However, where prior notice is impractical, the
company may temporarily cease service, providing that they:
1. promptly notify the customer.
2. give the customer an opportunity to correct the equipment problem.
3. inform the customer of the right to bring a complaint to the Federal Communication
You should also know that:
Your machine is not designed to be connected to a digital PBX system.
If you intend to use a computer modem or fax modem on the same phone line as your machine,
you may experience transmission and reception problems with all the equipment. It is
recommended that no other equipment, except for a regular telephone, share the line with your
machine.
If your area experiences a high incidence of lightning or power surges, we recommend that you
install surge protectors for both the power and the telephone lines. Surge protectors can be
purchased from your dealer or telephone and electronic specialty stores.
When programming emergency numbers and/or making test calls to emergency numbers, use a
non-emergency number to advise the emergency service dispatcher of your intentions. The
dispatcher will give you further instructions on how to actually test the emergency number.
This machine may not be used on coin service or party lines.
This machine provides magnetic coupling to hearing aids.
You may safely connect this equipment to the telephone network by means of a standard modular
jack, USOC RJ-11C.
REPLACING THE FITTED PLUG (FOR UK ONLY)
Important
The mains lead for this machine is fitted with a standard (BS 1363) 13 amp plug and has a 13 amp
fuse. When you change or examine the fuse, you must re-fit the correct 13 amp fuse. You then need
to replace the fuse cover. If you have lost the fuse cover, do not use the plug until you have another
fuse cover.
Contact the people from you purchased the machine.
The 13 amp plug is the most widely used type in the UK and should be suitable. However, some
buildings (mainly old ones) do not have normal 13 amp plug sockets. You need to buy a suitable
plug adaptor. Do not remove the moulded plug.
If you cut off the moulded plug, get rid of it straight away.You cannot rewire the plug and you
may receive an electric shock if you plug it into a socket.
Important warning:
You must earth this machine.
The wires in the mains lead have the following color code:
Downloaded from http://downloadcenter.samsung.com/content/UM/200907/20090721152022250/EN/english/... www.Manualslib.com
Commission pursuant to procedures set out in FCC Rules and Regulations Subpart E of Part
68.
Green and Yellow : Earth
Blue: Neutral
Brown : Live
manuals search engine
11
Page 6 of 12
8/4/2009