Installation - Para systems ETR500 User Manual

UPS Status
Self-Test
Normal
Boost
Buck
Self low Battery
Overload
Normal
Overload
Low Battery
Short/Fault Mode
Over-Bat/Bat Fault
INSTALLATION PLACEMENT
This UPS series is intended to be install in a temperature controlled environment
that is free of conductive contaminants. Avoid locations near heating devices, water
or excessive humidity, or where the UPS is exposed to direct sunlight. Select a
location which will provide good air circulation for the UPS at all times. Route power
cords so they cannot be walked on or damaged.

INSTALLATION

Be sure to read the installation placement and all the cautions before installing the
UPS. Place the UPS in the final desired location and complete the rest of the
installation procedure. These UPSs are shipped with the internal batteries discon-
nected. The batteries must be connected before putting these UPSs into service.
See the Connecting The Batteries procedure to connect the batteries.
Status LED and Alarm Table
Yellow LED
Green LED
All LEDs cycle (each LED Blinks 1/1.5seconds)
AC Mode
On
1-Blink/1.5sec
2-Blinks/sec
On
On
Battery Mode
Off
Off
Off 2-Blinks/sec
Off
Off
Red LED
Off
Off
Off Off
Off Off
2-Blinks/sec
Off
Off
2-Blinks/sec
On Off
On 2-Blinks/sec
Off
On
Off
Off
2-Blinks/sec
Alarm
1-Beep/5-sec
Off
Off
Off
3-Beeps/30-sec
2-Beeps/sec
1-Beep/5-sec
2-Beeps/sec
2-Beeps/5-sec
Continuous
3-Beeps/5-sec
7