Controls And Indicators - Para systems Minuteman ED10000T User Manual

Bypass Input found when running on CVCF
48 Er24
mode (CVCF mode not supported)
49 Er26
The UPS must be operated in normal mode in
50 Er27
parallel system
51 Er28 Bypass Overload Time out and cut off output.
52 Er29 Charger overcharges battery (>300Vdc)
53 Er30
The settings of both control board and driver
54 Er31
board are not matched together
55 Er32
56 Er33
57 Er34
58 CEr1
59 CEr2
60 CEr3
61 CEr4
62 CEr5
63 CEr6
(** Er7, Er19, Er25 are reserved
)
PFC Over-current
Inverter Balance error
Sync Signal error
Isolated transformer overheat
Balance function conflict
Utility voltage out of range
Bypass Voltage out of range
Inverter Voltage out of range
Load Percentage out of range
Battery Voltage out of range
UPS Output Voltage out of range
8
2.4.

Controls and Indicators

2.4.1 UPS Control panel
A LCD Display.
B N+1 (green) LED illuminates when the UPS is operating in the
Parallel/Redundant mode.
C Bypass (green) LED illuminates when the bypass input is normal. The
LED extinguishes in the Battery mode.
D Line (green) LED illuminates when the utility input voltage is within the
acceptable window. The LED extinguishes in the Battery mode.
E On/Alarm Silencer switch is to turn the UPS On or silence the audible
alarm in the Battery mode.
F Up arrow: Go to previous page or change the UPS setting.
G Enter key: To save the changes to the UPS setting.
H Down arrow: Go to next page.
I OFF switch is to turn the inverter off and transfers the UPS to the
Bypass mode.
J Special functions key: Log in/out.
K ECO (yellow) LED illuminates when the UPS is working in the ECO
(economic, Line-interactive) mode.
L Fault (red) LED illuminates when there is an abnormal condition or
there is an internal fault.
9