Radio Operation - Virtual Reality VRCD500-SDU Owner's Manual

Radio Operation

1. Choose a Radio Frequency
Choose American or European Frequency
by selecting the A/E switch. A is for
American Frequencies (87.7, 87.9, etc) and
E is for European frequencies (87.8, 88.0,
etc). The switch is on the main unit, behind
the front panel.
2. Choose Radio Band
Press the "BND/ID3" button on the face-
plate or remote to select one of the 3 FM
bands (FM1 - FM2 - FM3) or 2 AM bands
(AM1 - AM2). Each band can store 6 preset
stations, for a total of 30 preset memory
stations.
3. SEEK 1 & SEEK 2
Press and hold the Volume knob on the face-
plate, or the "SEL" button on the remote un-
til "DSP OFF" is shown on the LCD, then
press the Volume knob on the faceplate or
the "SEL" button on the remote to cycle
through the menu selections until "SEEK
1" is shown. Use the Volume knob on the
faceplate, or the +/- Button on the remote
to select either "SEEK 1" or "SEEK 2".
A. Seek 1
Press and hold the |<< or >>| button on the
faceplate or remote for more than 1 second.
The radio will seek the next strong and clear
frequency. Repeat to seek more stations in
your listening area with a strong signal.
B. Seek 2
Press and hold the |<< or >>| button on the
faceplate or remote for station search. The
search will not cease until you release the
button.
4. Mono/Stereo Reception Control
In FM radio mode, press MONO button on
the remote control to toggle between mono
reception or stereo reception. The display
will show "MONO" or "STEREO". Improve-
ment of reception of distant stations can be
done by selecting "MONO" operation which
may cut down some reception noise. The
"MONO/STEREO" function only works in
radio mode.
5. Save Your Preset Stations
There are Six numbered preset buttons
which can store and recall stations for each
band. There are 5 bands and 30 available
preset station slots. 3 FM bands, F1, F2,
and F3 making a total of 18 preset stations
in FM band. 2 AM bands, AM1 and AM2
making a total of total 12 preset stations in
AM band.
6. Automatic Store/Preset Scan
A. Show Stations Preset
While listening to the FM Radio, press and
hold the "F/PS" button on the faceplate or
the APS button on the remote for 1 second.
The receiver will automatically scan the
saved stations of the 3 FM Bands. When
listening to the AM radio, press "F/PS"
button on the faceplate or the "APS" button
on the remote for more than 3 seconds, the
receiver will automatically scan and save
stations for the 2 AM bands.
B. Reset Automatic Scan & Store
Press and hold the "F/PS" button on the
faceplate or the "APS" button on the remote
for 3 seconds and the receiver will scan the
radio stations with the strongest signal in
your area, then save them as pre-sets.
12