Basic Operation - Virtual Reality VRCD500-SDU Owner's Manual

Basic Operation

1. Tuning the Unit On / Off
Press any button to turn the unit on, the dis-
play will show a message WELCOME to
indicate it is ready for use. Press and hold
the POWER button again to turn the unit
off.
2. Mode Selection
Press the "MOD" Button on the faceplate
or the "MODE" button on the remote to se-
lect the play mode between SD Card, USB
Port, AUX, RADIO and CD PLAY.
3. Loudness Control
Press the "LUD" Button on the faceplate or
the "LOUD" button on the remote to em-
phasize the Bass output, the word "LOUD
ON" shown on the display indicates that
the loudness function is on. Press again
to cancel. While listening to the unit play
the letters "LUD" will be displayed on the
right side of the display to indicate that the
"LOUDNESS" function is on.
4. Mute Control
Press the "MUT" Button on the faceplate
or the "MUTE" button on the remote to ac-
tivate the Mute function, "MUTE ON" will
be shown on the LCD. Press MUT again or
rotate the volume knob to cancel.
5. Volume
Adjust the Volume by rotating the volume
knob on the faceplate or press the "+ or -"
button on the remote, the display will show
VOL 0 - 47 (Numbers indicate the volume
level).
6. Bass
Press the Volume knob on the faceplate or
the "SEL" button on the remote until the dis-
play shows BAS 0. Rotate the volume knob
on the faceplate or press the "+ or -" button
on the remote to adjust the bass level.
7. Treble
Press the Volume knob on the faceplate or
the "SEL" button on the remote until the
display shows TRE 0. Rotate the volume
knob on the faceplate or press the "+ or -
" button on the remote to adjust the treble
level.
8. Balance
Press the Volume knob on the faceplate or
the "SEL" button on the remote until the
display shows BAL R-L. Rotate the volume
knob on the faceplate or press the "+ or -"
button on the remote to adjust the volume
balance of left & right speakers.
9. Fader
Press the Volume knob on the faceplate or
the "SEL" button on the remote until the
display shows FAD 0. Rotate the volume
knob to adjust the volume balance between
the front & rear speakers.
10. Subwoofer Control
Press and hold the Volume knob on the face-
plate or the "SEL" button on the Remote
until the LCD displays "DSP OFF". Press
the Volume knob again and the LCD dis-
plays "WOOFER OFF". Rotate the Volume
knob to activate the subwoofer control
function, then leave the unit idle for your
desired setting to take effect. While listen-
ing to the unit play the letters "SUB" will
be displayed on the right side of the display
to indicate that the subwoofer function is
on. An external amplifier must be used
with a subwoofer.
11. Clock
The clock can be set anytime when the
power is ON. Press the "CLK" Button
once, then press and hold "CLK" Button
for 3 seconds, the time will blink on the
display.
1. Rotate the volume knob to the right to
10