Radio Operation - Virtual Reality VRCD400-SDU Owner's Manual

Radio Operation

1. Choose Radio Frequency
Choose American or European Frequency
by selecting the A/E switch. A is for
American Frequencies (87.7, 87.9, etc) and
E is for European frequencies (87.8, 88.0,
etc). The switch is on the main unit, behind
the front panel.
2. Choose Radio Band
Press the BD/ID3 button to select 3 FM
bands (FM1 - FM2 - FM3) and 2 AM bands
(AM1 - AM2). Each band can store 6 preset
stations, for a total of 30 preset memory
stations.
3. SEEK 1 & SEEK 2
Press and hold the SEL Button until "DSP
OFF" is shown on the LCD, then press the
SEL Button to cycle through the menu se-
lections until "SEEK 1" is shown. Use the
VOL +/- Button to select either "SEEK 1"
or "SEEK 2".
A. Seek 1
Press and hold the SEEK |<< or >>| Button
for more than 1 second. The radio will seek
the next strong and clear frequency station.
Repeat to seek more stations in your listen-
ing area with a strong signal.
B. Seek 2 Press and hold the SEEK |<< or
>>| Button for station search. The search
will not cease until you release the button.
4. Mono/Stereo Reception Control
In FM radio mode, press MONO button on
the remote control to toggle between mono
reception or stereo reception. The display
will show "MONO" or "STEREO". Improve-
ment of reception of distant stations can be
done by selecting "MONO" operation which
may cut down some reception noise.
5. Save Your Preset Stations
There are Six numbered preset buttons
which can store and recall stations for each
band. There are 5 bands and 30 available
preset stations slot. 3 FM bands, F1, F2,
and F3 making a total of 18 preset stations
in FM band. 2 AM bands, AM1 and AM2
making a total of total 12 preset stations in
AM band.
6. Automatic Store/Preset Scan
A. Show Stations Preset
While listening to the FM Radio, press and
hold the F/PS Button for 1 second. The
receiver will automatically scan the saved
stations of the 3 FM Bands. When listening
AM radio, press "F/PS" button for more
than 3 seconds, the receiver will automati-
cally scan and save stations for the 2 AM
bands.
B. Reset Automatic Scan & Store
Press and hold the F/PS button for 3 sec-
onds and the receiver will scan the radio
stations in your area, then save them as
pre-sets.
11