Basic Operation - Virtual Reality VRCD400-SDU Owner's Manual

Basic Operation

1. Tuning the Unit On / Off
Press the any button to turn the unit on, the
display will show a message WELCOME
to indicate it is ready for use. Press and hold
the POWER button again to turn the unit
off.
2. Mode Selection
Press the BD/ID3 for the Radio mode, Press
the "MOD" Button to select the play mode
between AUX, RADIO and CD PLAY.
3. Loudness Control
Press the LUD Button to emphasize the
Bass output, the word "LOUD ON" shown
on the display indicates that the loudness
function is on. Press again to cancel.
4. Mute Control
Press the MUT Button to activate the Mute
function. Press again or rotate the volume
knob to cancel.
5. Volume
Adjust Volume by simply rotating the vol-
ume knob, the display shows VOL then 0
(indicate the volume level).
6. Bass
Press SEL button until the display shows
BAS 0. Rotate the knob to adjust the bass
of high/low sound level.
7. Treble
Press SEL button until the display shows
TRE 0. Rotate the knob to adjust the bass
of high/low sound level.
8. Balance
Press SEL button until the display shows
BAL R-L. Rotate the knob to adjust the bal-
ance of left/right speakers.
9. Fader
Press SEL button until the display shows
FAD F-R. Rotate the knob to adjust the
volume balance between the front & rear
speakers.
10. Subwoofer Control
Press and hold the SEL button until LCD
display "DSP OFF".
again and LCD display "WOOFER OFF'.
Rotate volume to activate the subwoofer
control function, then leave the unit idle for
your desired setting to take effect. Make
sure the unit is connected to an external
amplifier.
11. Time Clock Setting
The time clock can be set anytime when
the power is on. Press the CLK Button and
then press and hold "CLK" Button for 3
seconds, the time will blink on the display.
1. Rotate the volume up button to adjust the
hour.
2. Rotate the volume down button to adjust
the minute.
3. Press the CLK Button again or leave the
unit idle for new setting to effect.
Press the CLK Button anytime to view the
time clock display.
12. Preset Beep Sound Off
1. Press the Sound Select
Seconds, the Display will show "DSP OFF".
2. Press the Sound Select button continu-
ously until the display show "BEEP ON",
press the volume up/down button to toggle
between it and "BEEP OFF", then leave
the unit idle for your desired setting to take
effect.
13. Preset Equalizer Function
Press and hold the SEL Button for 2 sec-
onds, the display will show "DSP OFF".
Rotate the Volume up/down button to choose
set the EQ sound effects. The choices are
POP, ROCK, CLASS, and FLAT.
10
Press SEL button
button for 2