The Audio Settings - Cisco Telepresence MX300 Administrator's Manual

Cisco TelePresence MX Series
AdministrAtor guide
Table of contents Introduction
The Audio settings
Audio PreferredOutputConnector
Select the preferred connector for the audio out. When the handset is in use the audio out goes
to the handset, and when hanged up the audio out goes to the preferred output connector.
Requires user role: ADMIN
Value space: <None/Internal>
None: The default audio output is the internal speaker.
Internal: The audio out goes to the internal loudspeaker. NOTE: Requires the "Audio
InternalSpeaker Mode" to be enabled.
Example: Audio PreferredOutputConnector: Internal
Audio InternalSpeaker Mode
Set the internal loudspeaker mode.
Requires user role: ADMIN
Value space: <On/Off>
On: The internal speakers are enabled.
Off: The internal speakers are disabled.
Example: Audio InternalSpeaker Mode: On
Audio Microphones Mute Enabled
Determine whether audio-mute is allowed or not. The default value is True.
Requires user role: ADMIN
Value space: <True/InCallOnly>
True: Muting of audio is always available.
InCallOnly: Muting of audio is only available when the device is in a call. When Idle it is not
possible to mute the microphone. This is useful when an external telephone service/audio
system is connected via the codec and is to be available when the codec is not in a call.
When set to InCallOnly this will prevent the audio-system from being muted by mistake.
Example: Audio Microphones Mute Enabled: True
Audio SoundsAndAlerts KeyTones Mode
Not applicable in this version.
D14850.02 MX Series Administrator Guide (TC5.0) | 2011 NOVEMBER | © 2011 Cisco Systems, Inc. All rights reserved.
Web interface Advanced settings Advanced settings Appendices
Audio SoundsAndAlerts RingTone
Select the ring tone for incoming calls.
Requires user role: USER
Value space: <Marbles/IceCrystals/Polaris/Alert/Discreet/Fantasy/Jazz/
Nordic/Echo/Rhythmic>
Range: Select a tone from the list of ring tones.
Example: Audio SoundsAndAlerts RingTone: Jazz
Audio SoundsAndAlerts RingVolume
Sets the ring tone volume for an incoming call.
Requires user role: USER
Value space: <0..100>
Range: The value goes in steps of 5 from 0 to 100 (from -34.5 dB to 15 dB). Volume 0 = Off.
Example: Audio SoundsAndAlerts RingVolume: 50
Audio VolumeHandset
Set the volume on the handset.
Requires user role: ADMIN
Value space: <0..100>
Range: The value goes in steps of 5 from 0 to 100 (from -34.5 dB to 15 dB). Value 0 = Off.
Example: Audio VolumeHandset: 70
Audio VolumeHeadset
Set the volume on the headset.
Requires user role: ADMIN
Value space: <0..100>
Range: The value goes in steps of 5 from 0 to 100 (from -34.5 dB to 15 dB). Value 0 = Off.
Example: Audio VolumeHeadset: 70
Audio Volume
Set the volume on the loudspeaker.
Requires user role: USER
Value space: <0..100>
Range: The value goes in steps of 5 from 0 to 100 (from -34.5 dB to 15 dB). Value 0 = Off.
Example: Audio Volume: 70
34
www.cisco.com