Placing Calls - Cisco Telepresence MX300 Administrator's Manual

Cisco TelePresence MX Series
AdministrAtor guide
Table of contents Introduction
Placing calls
You can use the Call Control page of the web interface to
initiate a call.
NOTE: Even if the web interface is used to initiate the call it
is the video system (display, microphones and loudspeakers)
that is used for the call; not the PC running the web interface.
Calling someone
Enter one or more characters in the address input field until
the name you want to call appears in the dynamic search list
or, enter the complete name or number. Then click Dial.
Click End all to disconnect the call.
Sharing contents
Select a Presentation Source from the drop down list, and
click the Start Presentation button.
Normally a PC is used as presentation source, but other
options may be available depending on your system setup.
To stop the content sharing, click the Stop Presentation
that becomes visible while sharing.
D14850.02 MX Series Administrator Guide (TC5.0) | 2011 NOVEMBER | © 2011 Cisco Systems, Inc. All rights reserved.
Web interface Web interface Advanced settings
button
Address input field
Call Control
Appendices
20
www.cisco.com