Controlling And Monitoring A Call - Cisco Telepresence MX300 Administrator's Manual

Cisco TelePresence MX Series
AdministrAtor guide
Table of contents Introduction
Controlling and monitoring a call
You can control and monitor several call features using the
Call Control page.
Adjusting the sound volume
Use + and - on the volume control bar to adjust the sound
volume of your system (not the keyboard + and - keys).
Deactivating the microphone
Use the Mute button when you want to deactivate the
microphone for privacy reasons.
When the microphone is muted, the button is replaced by an
Unmute button. Use this button to re-activate the microphone.
Controlling the camera
First, click the Camera Control button. Then, in the window
that opens, use + and - to adjust the zoom and the arrow keys
to adjust the camera's angle.
If a camera preset is defined it is listed to the right. Apply the
preset by clicking its name.
Call settings
When you load the Call Control page, the default call bit rate
and the default call protocol are shown in the
Call protocol boxes, respectively. If preferred, you can select
another bit rate or another protocol from the drop down lists.
You can not change these settings during a call.
Call status
Click Show details to provide information on call rate,
encryption, as well as important video and audio parameters.
Hide details removes the information.
D14850.02 MX Series Administrator Guide (TC5.0) | 2011 NOVEMBER | © 2011 Cisco Systems, Inc. All rights reserved.
Web interface Web interface Advanced settings
Call bit rate and
bit rate
Call Control
Appendices
Camera control
Call Call
protocol
21
Volume control
Microphone mute
Show/hide call status
www.cisco.com