Casablanca Ceiling Fan Owner's Manual page 7

C
APISTRANO
Casablanca
INSTALLING THE BLADE/BLADE HOLDER TO FAN MOTOR
Step 8. To reach the blade holder mounting
holes in the fan motor the dummy switch
housing must be removed.
9
Take out the two 5-32 X /
32
ing the dummy switch housing and remove.
Put the two (2) screws aside for the mo-
ment, they will be used in Step 15 to install
the switch housing after the blades are in-
stalled.
The dummy switch housing is used only when
shipping the fan.
Note: Save these two screws–they
will be used in Step 15!
BLADE SCREW
(4 PER BLADE)
RUBBER GROMMET
(4 PER BLADE)
Step 9. Insert a rubber grommet through
each blade hole of every blade. Inspect
both sides of the blade to assure that
the lips of the grommet are fully engaged.
CORRECT INSTALLATION
INCORRECT INSTALLATION
6
PREPARATION
" screws secur-
DUMMY
SWITCH HOUSING
MOUNT SCREW
5-32 X
(2)
BLADE & BLADE HOLDER HARDWARE
RUBBER GROMMET INSTALLATION
9 / "
32
BLADE
HOLDER
DUMMY
SWITCH
HOUSING
BLADE HOLDER
SCREW
(2 PER BLADE)