Generic Dial-Up Method - Non-Windows - Multitech MultiModem Cell MTCBA-E1 User Manual

Chapter 3 – Using Your Wireless Modem
Disconnecting
To disconnect the connection, right click on the connection icon in your system tray at the bottom right-hand
1.
corner of your screen.
Scroll up and click on Disconnect.
You should now be disconnected from the Internet.

Generic Dial-Up Method - Non-Windows

If CDMA, dial onto the network using AT#777
1.
If GPRS/EDGE:
2.
a. To set up an Access Point Name (APN) enter:
AT+CGDCONT=1, "IP","<APNSERVER>"
Where <APNSERVER> is the APN server supplied by your carrier
b. dial onto the network using AT*99***1#
Serial Baud Rate
Your MultiModem Cell is defaulted to a serial baud rate of 115200 from the factory. To enjoy faster baud rates,
you can manually set the modem to a higher speed (230400, 460800, or 921600) using the AT+IPR=<baudspeed>.
However, you must make sure the host serial port is capable of the new speed. If the new speed is set and the
host hardware is not capable of the higher speed, you will need to find a host that is capable.
28 Multi-Tech Systems, Inc. MultiModem Cell User Guide