Radar Display Appearance - Garmin GPSMAP 6008 Owner's Manual

Adjusting Crosstalk Clutter on the Radar Screen
You can reduce the appearance of clutter caused by interference from another nearby radar source. On is the
default value for the crosstalk setting.
Note: Depending upon the radar in use, the crosstalk setting configured for use in one radar mode may or
may not be applied to other radar modes or to the Radar Overlay
1. From the Home screen, select Radar.
2. Select Cruising, Harbor, offshore,
3. Complete an action:
Menu Noise Rejection
• Select >
• Configure the setting for both screens in Dual Range mode. Select
Crosstalk on
> for the GPSMAP 6000 series. Select
GPSMAP 7000 series.

Radar Display Appearance

Data Bar Settings
Data bars can appear in all Radar modes, and they provide real-time, at-a-glance information.
All data bars configured for use in one radar mode appear in every other radar mode. All data bars configured
for use on the Radar Overlay appear only on the Radar Overlay, and must be configured separately.
Showing the Cruising Data Bar on the Radar Screen
The cruising data bar shows GPS speed, GPS heading, depth, and GPS position data.
1. From the Home screen, select Radar.
2. Select Cruising, Harbor, or
3. Select Menu > Radar Setup
Configuring the Cruising Data Bar on the Radar Screen
You should show the cruising data bar before you configure it
The cruising data bar is divided into four sections, and each section appears in a different corner of the Radar
screen. You can select the type of data that appears in each section of the data bar.
1. From the Home screen, select Radar.
2. Select Cruising, Harbor, or
3. Select Menu > Radar Setup
4. Select top Left.
5. Select the type of data to appear in the top left section of the data bar.
6. Repeat steps 4 and 5 for the
GPSMAP 6000/7000 Series Owner's Manual
®
Dual Range
or
Crosstalk on
> >
offshore
mode.
> Data Bars > Cruising
offshore mode.
> Data Bars > Cruising
top Right, Bottom Left, and
(page 85).
Sentry
mode.
for Cruising, Harbor, Offshore, or Sentry mode.
>
Left Noise Rejection
>
> on.
(page 91).
> Data Bar Setup.
Bottom Right
sections of the data bar.
Radar
Menu Noise Rejection
>
Crosstalk on
> > for the
>
91