Waypoints And Routes On The Radar - Garmin GPSMAP 6008 Owner's Manual

Measuring the Range and Bearing to a Target Object
You must show the VRM and the EBL before you can adjust them
The VRM and the EBL configured for one mode are applied to all other radar modes.
1. From the Home screen, select Radar.
2. Select Cruising, Harbor, offshore, or
3. Complete an action:
• Select Menu > Adjust VRM/eBL
• Configure the setting for the short-range screen in Dual Range mode. Select
VRM/eBL > Move VRM/eBL
Move VRM/eBL
• Configure the setting for the long-range screen in Dual Range mode. Select
VRM/eBL Move VRM/eBL
>
Move VRM/eBL
4. Complete an action:
• For the GPSMAP 6000 series, use the Rocker to adjust the diameter of the VRM and the angle of the
EBL, so that the intersection point of the VRM and EBL is at the target location
• For the GPSMAP 7000 series, touch the target location.
The range and the bearing to the target location appear in the upper-left corner of the screen.
5. Select Done.
Waypoints and Routes on the Radar Screen
Marking a Waypoint on the Radar Screen
1. From the Home screen, select Radar.
2. Select a radar mode.
3. Complete an action:
• For the GPSMAP 6000 series, use the Rocker to select a location.
• For the GPSMAP 7000 series, touch a location.
4. Select Create Waypoint.
Showing Waypoints on the Radar Screen
You can show waypoints that are within the range shown on the Radar screen. This setting does not apply to
the Radar Overlay.
1. From the Home screen, select
2. Complete an action:
Show
• Select to show all waypoints.
Navigation only
• Select
GPSMAP 6000/7000 Series Owner's Manual
®
Dual Range.
> Move VRM/eBL
for the GPSMAP 6000 series. Select
for the GPSMAP 7000 series.
for the GPSMAP 6000 series. Select
for the GPSMAP 7000 series.
Radar Radar Setup
>
to show only waypoints associated with the currently active route.
(page 80).
for Cruising, Harbor, or Offshore Mode.
Left
Right
Appearance > Waypoints.
>
Radar
> Menu > Adjust
> Adjust VRM/eBL >
> Menu > Adjust
Adjust VRM/eBL
> >
81