Table of Contents
Advertisement
At first, the enabler for the example PCMCIA (FCPOINT.EXE) in
the CONFIG.SYS file is loaded and displays a message similar to
the following (depending on your specific device):
-----------------------------------------------------------
PC Card driver for external ATAPI-IDE Drives
Rev:2110
Found PCCARD: FREECOM PCCARD-IDE RV#052 V5.0
Initialization using C:\FC\FCPOINT.INI completed!
-----------------------------------------------------------
If a different driver message is displayed, this does not indicate
that an error has occurred. Please refer to the chapter
"Troubleshooting" only if the text contains the word "ERROR"
or "WARNING" . The driver is then loaded and displays the
following – depending on the device (for example FCATAPI.SYS):
ATAPI-CD: ATAPI IDE CD-ROM Device Driver Rev. 2130 DOS
ATAPI-CD: Copyright (C) Freecom Technologies 1995-2001
ATAPI-CD: Drive: Toshiba CD-ROM XM-6202B 1110
ATAPI-CD: CD-ROM drive installation successfully completed
The driver assigns the device the first available letter following
your last hard disk For example, if you only have one hard drive
C:, the device will be assigned the drive letter D:.
The driver MSCDEX.EXE will also be called up for devices with
a CD ROM drive. It is responsible for assigning the drive letter
to the CD-ROM.
Driver installation
23
Advertisement
Table of Contents
