Under Windows 98 - Targus Noteworthy Instructions Manual

TARGUS Noteworthy DVD-ROM
3.2 Driver installation under Windows 98
No special software is required to install your TARGUS PC Card
Cable. We however recommend using the driver on diskette
that we have enclosed. This has been specially developed and
is faster than the Standard Windows driver.
TARGUS High Speed driver (recommended)
Note: If you are not prompted to install the driver, Windows
will install the default driver automatically. Proceed then as
described in the section on later installation of the TARGUS
High Speed driver.
To install the driver, insert the TARGUS installation diskette in
your PC drive.
1. Plug the TARGUS PC Card Cable into the PCMCIA slot of
your PC.
2. The window "Hardware Installation Wizard" opens. The
TARGUS PC Card Cable is recognized as "Standard IDE/ESDI
Hard Disk Controller".
3. In the next window the option for finding the best driver
for the device has been selected. Confirm with "Next".
4. In the next window select the floppy drive to install the
driver. Click on "Next".
5. The driver is loaded from the diskette. Click on "Next" to
continue the installation.
6. In the next window click on "Next" to confirm the
installation.
7. After completion of the installation, click on "Finish". Your
TARGUS drive appears with a new drive letter under "My
Computer". The installation is then complete.
10