Under Windows Me - Targus Noteworthy Instructions Manual

3.3 Driver installation under Windows ME
No special software is required to install your TARGUS PC Card
Cable. We however recommend using the driver on diskette
that we have enclosed. This has been specially developed and
is faster than the Windows driver.
TARGUS High Speed driver (recommended)
Note: If you are not prompted to install the driver, Windows
will install the default driver automatically. Proceed then as
described in the section on later installation of the TARGUS
High Speed driver.
To install the driver, insert the TARGUS installation diskette in
your PC drive.
1. Plug the TARGUS PC Card Cable into the PCMCIA slot of
your PC.
2. The window "Hardware Installation Wizard" opens. The
TARGUS PC Card Cable is recognized as "Standard IDE/ESDI
Hard Disk Controller".
3. Windows ME automatically detects and installs the TARGUS
High Speed driver from diskette.
4. After completion of the installation, click on "Finish". Your
TARGUS drive appears with a new drive letter under "My
Computer". The installation is then complete.
Windows ME Default Driver
No driver software is required to install the Windows default
driver.
1. Plug the TARGUS PC Card Cable into the PCMCIA slot of
your PC.
2. The window "Hardware Installation Wizard" opens. Your
TARGUS PC Card Cable is recognized as "Standard IDE/ESDI
Hard Disk Controller". The option for finding the best
driver has been selected (Recommended). Confirm with
"Next".
3. The Windows ME Default Driver is installed automatically.
4. In the next window, click on "Finish" to conclude the driver
installation. Your TARGUS drive now appears with a new
drive letter under "My Computer".
Driver installation
13