Rackmount Installation - Preparations - GE VH Series 700 User Manual

3.3.2

Rackmount installation - preparations

1 Place the UPS horizontally on a table or
desk.
2. Re-position the operating panel: remove
the 2 screws that hold the panel and rotate
the panel 90 degrees counterclockwise.
Don't pull out the panel! Tighten the 2
screws again.
3. Install the two mounting brackets that
came with the unit using the screws
provided.
4. Connect the DC connector of the internal
batteries.
5. Assemble the front panel: insert the two
metal clamps at the rear of the panel into
the holes at the right side of the UPS, then
click the front panel into position.
6. Install the UPS into a 19' rack. The UPS
cabinet must be supported by mounting
rails, do not mount it by using the
mounting brackets only. Fix the mounting
brackets on the 19 inch enclosure with
screws.
The VH Series UPS is now ready for further
connections, please proceed with section 3.3.3.
modifications reserved
OPM_VHE_XXX_0K7_3K0_XGB_V010
fig. 3.3.2: installation preparations - rackmount
7 User manual VH Series 700-3000 UPS 1.0 (GB)
1 2
3
4
5