Table of Contents
Advertisement
3
Cold Boot
A cold boot is a complete reset of the J Series in which all applications are forcibly
closed and the RAM is completely cleared. Registry is restored from persistent
memory if a saved copy is available (see Registry Applet, par. 3.8.2). Applications
and data stored on file system are preserved. A cold boot is necessary when the
Windows Mobile operating system locks up and the warm boot command does not
work.
To perform a cold boot, press and hold the following keys simultaneously:
Clean Boot
A clean boot is a cold boot that causes the device to be restored to a clean
configuration. The J Series will be reset to its factory configuration only if the user
has not installed any additional package. Please note that you will lose any
applications and data stored in persistent flash memory.
To perform a clean boot, follow these steps:
1.
Perform a Cold Boot (see Cold Boot).
2.
Quickly release all the keys when the screen goes black.
3.
Within 1 second press and hold down the Esc and 0 keys until the left orange led
starts blinking.
4.
Release the Esc and 0 keys.
5.
Enter 1 to proceed with the Clean Boot sequence. Enter 0 to cancel the Clean
Boot and proceed with a Cold Boot.
Warm Boot
Registry
Restored
flash
File
Preserved
System
36
Cold Boot
from
Restored
flash
Preserved
DATALOGIC J SERIES™
Clean Boot
from
Clean configuration (no user
config)
Clean Installation (no user files)
Advertisement
Table of Contents
