Table of Contents
Advertisement
1
1.4
INSERTING MINI SD CARD
With Datalogic J Series™ PDA, it is possible to add a Mini SD Card for additional
storage capacity. To access the Mini SD card slot, unscrew the cover at the side of
Datalogic J Series (see Figure A) and then proceed as follows:
1.
Before inserting the Mini SD card, peel the adhesive pull tab and stick it onto to
the Mini SD card as shown in the picture below:
2.
Open the Mini SD card slot by unscrewing the two screws:
3.
Insert the card with the written part upward and push it until it clicks into place:
To remove the Mini SD card slightly push it toward the inside until it clicks; the card is
released, pull it out using the adhesive pull tab.
4
DATALOGIC J SERIES™
Advertisement
Table of Contents
