Table of Contents
Advertisement
2
TANDBERG MediaP
Videoconferencing System
INSTALLATION
The TANDBERG MediaP
2
high resolution projector, and audio system with speaker and microphone.
Refer the following pages for system setup and installation.
SMART Board
Interactive
Whiteboard
NETWORK
POWER
Precautions
•
Never install telephone wiring during a lightning storm. Avoid using a
telephone (other than a cordless type) during an electrical storm.
There may be a remote risk of electrical shock from lightning.
•
Never install telephone jacks in wet locations unless the jack is
specifically designed for wet locations.
•
Never touch uninstalled telephone wires or terminals unless the
telephone line has been disconnected at the network interface.
•
Use caution when installing or modifying telephone lines.
•
Do not use the telephone to report a gas leak in the vicinity of the
leak.
•
The socket outlet shall be installed near to the equipment and shall
be easily accessible.
•
Never install cables without first switching the power OFF.
D505068.02
components are: TANDBERG Edge MXP Codec, Precision HD Camera, lockable mobile cart,
MICROPHONE
USB-B
RCA
USB-A
AUDIO
•
1TR6 network type is not approved for connection directly to the
telecommunications network. This network type is only to be used
behind a PABX.
•
X.21 network type is not approved for connection directly to the
telecommunications network. This network type is only to be used
together with already approved equipment, and is not meant for
direct connections to the telecommunication networks.
•
V.35/RS-449/RS-366 network type is not approved for connection
directly to the telecommunications network. This network type is
only to be used together with already approved equipment, and is
not intended for direct connection to the telecommunication
networks.
•
This product complies with directives: LVD 73/23/EC, EMC
89/366/EEC, R&TTE 99/5/EEC
USB-A
USB-B
VGA/DVI
2
TANDBERG MediaP
8
Advertisement
Table of Contents
