Armrest; Seat Heaters - Toyota 4Runner 2003 Operating Manual

For your safety and comfort, adjust the
head restraint before driving.
To raise: Pull it up.
To lower: Push it down while pressing the
lock release button.
Front head restraints—You can also move
the head restraint forward or backward. If
such adjustment is desired, pull or push
the base of the head restraint.
Rear head restraints—When an occupant
sits on the rear seat, always pull up the
rear head restraint to the lock position.
The head restraint is most effective when
it is close to your head. Therefore, using
a cushion on the seatback is not recom-
mended.
CAUTION
D
Adjust the center of the head re-
straint so that it is closest to the
top of your ears.
D
After adjusting the head restraint,
make sure it is locked in position.
D
Do not drive with the head re-
straints removed.
'03 4Runner_U (L/O 0211)

Armrest

To use the armrest, pull it out as
shown above.
This armrest is equipped with a cup hold-
er and tray. (For details, see "Rear cup
holders and tray" on page 230 in Section
1–9.)
NOTICE
To prevent damage to the armrest,
avoid putting heavy loads on it.

Seat heaters

To turn on the seat heater, move the
dial forward ("L" dial for the left front
seat and "R" dial for the right front
seat). To turn it off, move the dial back-
ward until it stops.
At this time, the indicator light will illu-
minate to indicate the seat heater is
operating.
Move the dial forward or backward to ad-
just to the desired temperature. When the
seat heater is not in use, move the dial
fully backward.
The key must be in the "ON" position.
2003 4RUNNER from Oct. '02 Prod. (OM35804U)
49