Toyota 4Runner 2003 Operating Manual page 290

When connecting a jack handle extension
with jack handle end, use a Phillips- head
screwdriver or jack handle to tighten the
bolts on the joints as shown in the il-
lustration.
When connecting the jack handle with ex-
tension, tighten the bolt on the joint se-
curely.
When you tighten the bolt, make sure that
it fits into the depression on the joint.
284
'03 4Runner_U (L/O 0211)
NOTICE
Tighten all joints securely. Otherwise,
the extension may come off and it
may damage the paint or vehicle
body.
—Raising your vehicle
Front of vehicle
6. After making sure that no one is in
the vehicle, as the jack touches the
vehicle and begins to fit, double-
check that it is properly positioned.
Rear side only—
When positioning the jack under the rear
axle housing, make sure the groove on
the top of the jack fits with the rear axle
housing.
2003 4RUNNER from Oct. '02 Prod. (OM35804U)