Toyota 4Runner 2003 Operating Manual page 33

If the battery is disconnected or run
down, the power back window may not
operate automatically and the jam protec-
tion function will not function correctly af-
ter you reconnect, replace or recharge the
battery. In any of these cases, you should
normalize the power back window with the
power back window switch.
To normalize the power back window:
1. Push the " " (down) switch and lower
the window halfway.
2. Push the " " (up) switch until the win-
dow closes and hold the switch for a
second.
Make sure that the window opens and
closes automatically. If the power back
window cannot be operated properly, have
it checked by your Toyota dealer.
OPERATING FROM INSIDE
The ignition key must be in the "ON" posi-
tion.
Normal operation: To open or close the
back window, quickly push and release the
" " (down) or " " (up) switch.
'03 4Runner_U (L/O 0211)
Automatic operation: To open or close
the back window, push and hold the " "
(down) or " " (up) switch. The window
will fully open or close. To stop the win-
dow partway, push the switch on either
the " " (down) or " " (up) side briefly.
Key off operation: If both front doors are
closed, it works for 43 seconds even after
the ignition switch is turned off. It stops
working when either front door is opened.
Jam protection function: During automat-
ic closing operation or key off closing op-
eration, the window stops and opens half
way if something gets caught between the
window and window frame.
If the window receives a strong impact,
this function may work even if nothing is
caught.
CAUTION
D
Never try jamming any part of your
body to make the jam protection
function work intentionally.
D
The jam protection function may
not work if something gets caught
just before the window is
closed.
If you push in the window lock switch on
the driver's door, the back window cannot
be operated.
fully
2003 4RUNNER from Oct. '02 Prod. (OM35804U)
27