Switching An Input To An Output; The Sto And Rcl Keys; Storing An Input/Output Configuration; Recalling An Input/Output Configuration - Kramer RC-IR2 User Manual

7.3.2

Switching an Input to an Output

To switch an input to an output after assigning the machine number and group
number, do the following:
1. Press a Selector key number for the output
2. Press a Selector key number for the input.
For example, to switch INPUT 3 to OUTPUT 5 on a switcher, press <5> and
then <3> (in the single digit mode).
In the double-digit mode, press the <--> key and then <0/10>, <5> and
<0/10>, <3>.
7.3.3

The STO and RCL Keys

You can store and recall input/output configurations
7.3.3.1

Storing an Input/Output Configuration

To store the current status in memory, do the following:
1. Press the STO key.
2. Press one of the Selector keys (this will be the setup # in which the current status
is stored).
The memory stores the data at that reference.
7.3.3.2

Recalling an Input/Output Configuration

To recall an input/output configuration, do the following:
1. Press the RCL key.
2. Press the appropriate Selector key (the key # corresponding to the setup #).
The memory recalls the stored data from that reference.
1 When switching units categorized in group 11 and in groups 1, 2, 3, 4, 14, 15 and 16, ignore step 1 which is inapplicable to
units with just one output
2 Check the switcher' s user manual to determine the number of configurations you can store. For example for the VP-66ETH,
you can store up to six configurations
12
The Router Mode Keys
1
.
2
using the selector keys.
KRAMER: SIMPLE CREATIVE TECHNOLOGY