Safety Instruction - Chauvet Mini Legend Wash DMX-427W User Manual

1. Safety Instruction

Please read carefully the instruction, which includes important
information about the installation, usage and maintenance.
WARNING
Please keep this User Guide for future consultation. If you sell the unit to another user, be
sure that they also receive this instruction booklet.
Unpack and check carefully there is no transportation damage before using the unit.
Before operating, ensure that the voltage and frequency of power supply match the power
requirements of the unit.
The unit is designed for use with the ELC 24V 250W lamp. Do not use any other type of
lamp.
It's important to ground the yellow/green conductor to earth in order to avoid electric
shock.
The unit is for indoor use only. Use only in a dry location.
The unit must be installed in a location with adequate ventilation, at least 50cm from
adjacent surfaces. Be sure that no ventilation slots are blocked.
Disconnect main power before fuse/lamp replacement or servicing.
Replace fuse/lamp only with the same type.
Make sure there are no flammable materials close to the unit while operating, as it is fire
hazard.
Use a safety cable when mounting this unit. Do not lift the unit by the head. Always lift or
move by holding the base.
Maximum ambient temperature is TA: 40
higher than this.
Unit surface temperature may reach up to 85
during its operation, and allow about 15 minutes to cool down before replacing bulb or
servicing, as the unit could be very hot.
In the event of a serious operating problem, stop using the unit immediately. Never try to
repair the unit by yourself. Repairs carried out by unskilled people can lead to damage or
malfunction. Please contact CHAUVET. Always use the same type spare parts.
Never connect the device to any dimmer pack.
Do not touch any wire during operation as high voltage may cause electric shock.
o
C. Do not operate where the temperature is
o
C. Do not touch the housing bare-hand
.
G. If The pan belt is broken
1. Turn off the main power.
2. Unscrew all the screws (A) and open the base-housing cover (B).
3. Unplug all the connecting wires (C) that from the arm to PC board and igniter.
4. Unscrew the screws (D) that hold the axis gear (E).
5. Install a new belt (F) by going through all connecting wires that run from the arm to base,
and through the bridge for correct position.
6. Set the gear axis on the bridge and screw in. Note: do not press the belt.
7. Put the belt around the axis gear and motor gear.
8. Plug all the connecting wires (C) from the arm to PC board and igniter.
9. Adjust the pan home position.
10. Screw the base-housing cover (B).
2-