Table of Contents
Advertisement
5. How To Control The Unit
You can operate the unit in three ways:
1. By master/slave with built-in preprogram function
2. By easy controller
3. By universal DMX controller
There is need to turn the unit off when you change the DMX address, as the new DMX
address setting will be effected at once. Every time you turn the unit on, it will show AE-4W on
the display and move all the motors to their 'home' position and you may hear some noises for
about 20 seconds. After that the unit will be ready to receive DMX signal or run the built in
programs.
5.1 Master/Slave Built In Preprogrammed Function
By linking the units in master/slave connection, the first unit will control the other units to give
an automatic, sound activated, synchronized light show. This function is good when you want
an instant show. You have to set the first unit in master mode
(show 1) or
(show 2) mode. Its DMX input jack will have nothing plugged into it and Its
master LED will be constantly on and sound LED will flash to the music. The other units will
have to be set in slave mode
mode, Their DMX cables plugged into the DMX input jacks (daisy chain) and the slave led
lights will constantly on.
2-light show
In
(slave mode),
means the unit works normally and
show. In order to create a great light show, you can set
contrast movement to each other, even if you have two units only.
and select
and select
(normal) or
on the second unit to get
4.2 Main Function
To select any of the given functions, press the MENU button until the required one is showing
on the display. Select the function by pressing the ENTER button and the display will blink.
Use the DOWN and UP buttons to change the mode. Once the required mode has been
selected, press the ENTER button to setup or it will automatically return to the main functions
without any change after idling 8 seconds. To go back to the functions without any change
press the MENU button. The main functions are shown below:
7-
(2 light show)
means 2-light
DMX512 Address Setting
Press the MENU button until
the display will blink. Use the DOWN and UP buttons to change the DMX512 address. Once
the address has been selected, press the ENTER button to setup or the unit will automatically
return to the main functions without any change after 8 seconds. To go back to the functions
without any change, press the MENU button again.
DMX512 Address Setting
Show Mode " Show 1 "
Show Mode " Show 2 "
Slave Mode " Normal "
Slave mode " 2 Light Show "
Normal Color
Split Color
Pan Normal
Pan Inversion
MENU
Tilt Normal
Tilt Inversion
Display Normal
Display Inversion
Self-Test
Fixture Hours
Reset
is shown on the display. Press the ENTER button and
Advertisement
Table of Contents
