Setting Operation Modes - Graco PRECISIONSWIRL 310554V Instructions-Parts List Manual

PrecisionSwirl Module Operation
F . 12
IG

Setting Operation Modes

The PrecisionSwirl module has two operating states:
• Automatic mode — enables the PrecisionSwirl
orbital dispenser to be controlled by a remote signal
source, such as a robot control. Motor speed can be
controlled by a 0-10 VDC analog signal.
• Manual mode — enables the PrecisionSwirl orbital
dispenser to swirl when you press the
RUN/ENABLE button on the control assembly.
Swirling continues until the STOP button is pressed.
22
Material flow rate and "ON/OFF" flow are not con-
trolled by the PrecisionSwirl orbital dispenser.
These must be controlled by the other interfaces.
Contact your Graco Distributor for assistance.
The PrecisionSwirl orbital dispenser is in an idle state
until you press the RUN/ENABLE button on the control
assembly. The only time the PrecisionSwirl orbital dis-
penser can swirl material is when the RUN/ENABLE
button is pressed in either Automatic or Manual mode.
When the STOP button is pressed, the PrecisionSwirl
orbital dispenser becomes idle and will not swirl mate-
rial.
The procedures in this section configure the module for
manual or automatic operation.
8030A
310554V