RAM 3500 2012 User Manual page 19

• To program a Key Fob to the memory position, place the ignition switch in the
LOCK position and remove the Key Fob, press and release the LOCK button
on the Key Fob to be programmed within 5 seconds of pressing button 1 or 2.
• Press 1 or 2 to recall the saved positions, or press UNLOCK on the
programmed Key Fob.
• Refer to the Owner's Manual on the DVD for further details.
Manual Seats
Forward/Rearward
• Lift up on the adjusting bar located
at the front of the seat near the floor
and release at the desired position,
then release the handle to lock the
seat into position.
Recliner
• Lift the recliner lever located on the
outboard side of the seat, lean back
and release at the desired position.
Do not place any article under a power seat or impede its ability to move as
it may cause damage to the seat controls. Seat travel may become limited
if movement is stopped by an obstruction in the seat's path.
• Adjusting a seat while the vehicle is moving is dangerous. The sudden
movement of the seat could cause you to lose control. The seat belt
might not be properly adjusted, and you could be severely injured or
killed. Only adjust a seat while the vehicle is parked.
• Actuating the recliner handle will allow the seatback to swing (dump)
forward on manual recliner seats. Do not stand or lean in front of the seat
while actuating the handle. The seatback may swing forward and hit you,
causing injury. This dump feature allows access to the storage bin behind
the seat. To avoid injury, place your hand on the seatback and actuate
the handle, then position the seatback in the desired position.
• Do not ride with the seatback reclined so that the seat belt is no longer
resting against your chest. In a collision, you could slide under the seat
belt and be severely injured or killed. Use the recliner only when the
vehicle is parked.
GETTING STARTED
CAUTION!
WARNING!
17