Operating Your Vehicle; Engine Break-In Recommendations; Turn Signals/Wiper/Washer/High Beams Lever - RAM 3500 2012 User Manual

ENGINE BREAK-IN RECOMMENDATIONS

• A long break-in period is not required for the engine and drivetrain
(transmission and axle) in your vehicle.
• Drive moderately during the first 300 miles (500 km). After the initial 60 miles
(100 km), speeds up to 50 or 55 mph (80 or 90 km/h) are desirable.
• While cruising, brief full-throttle acceleration within the limits of local traffic
laws contributes to a good break-in. Wide-open throttle acceleration in low
gear can be detrimental and should be avoided.
• The engine oil installed in the engine at the factory is a high-quality energy
conserving type lubricant. Oil changes should be consistent with anticipated
climate conditions under which vehicle operations will occur. For the
recommended viscosity and quality grades, refer to "Maintaining Your
Vehicle". NON-DETERGENT OR STRAIGHT MINERAL OILS MUST NEVER BE
USED.
• A new engine may consume some oil during its first few thousand miles
(kilometers) of operation. This should be considered a normal part of the
break-in and not interpreted as an indication of difficulty.

TURN SIGNALS/WIPER/WASHER/HIGH BEAMS LEVER

Turn Signals/Lane Change Assist
• Tap the lever up or down once and the turn signal (right or left) will flash three
times and automatically turn off.
Wipers
Intermittent, Low And High Operation
• Rotate the end of the lever to the first detent position for one of five
intermittent settings, the second detent for low wiper operation and the third
detent for high wiper operation.
Washer Operation
• Push the end of the lever inward to the second detent and hold for as long as
spray is desired.

OPERATING YOUR VEHICLE

21