Setting Time; Radio; Listening To Radio; Presetting Stations Manually - Alpine CDE-103BT Owner's Manual

Setting Time
Radio
SOURCE/<!>
BAND
1
Press and hold SOUND/SETUP for at least
2 seconds to activate the SETUP mode.
2
Turn the Rotary encoder to select the CLOCK ADJ
mode, and then press
~/II/ENT.
The time indication will blink.
3
Turn the Rotary encoder to adjust the hours while
the time indication is blinking.
4
When the hour has been adjusted, press
~/II/ENT.
5
Turn the Rotary encoder to adjust the minutes
while the time indication is blinking.
6
Press and hold SOUND/SETUP for at least 2
seconds to return to normal mode.
[I
TUNE/A.ME
Listening to Radio
Preset buttons
(1 through 6)
• To synchronise the clock to another clock/watch or radio time
announcement, press and hold
~/II
lENT for at least 2 seconds
after sening the "hour." Minutes will reset to "00".
If
the display
shows over "30" minutes when you do this, the time will advance one
hour.
• Pressing
~IMUTE
will return to the previous mode.
• If
no operation is peiformed for 60 seconds, the unit will return to
normal mode automatically.
Controllable with Remote Control
This unit can be controlled with an optional Alpine
remote control. For details, consult your Alpine dealer.
Point the optional remote control transmitter at the
remote-control sensor.
Remote control sensor
1
Press SOURCE/<!> to select TUNER mode.
2
Press BAND repeatedly until the desired radio band
is displayed.
F1 (FM1)
-7
F2 (FM2)
-7
AM
-7
F1 (FM1)
3
Press TUNE/A.ME to select the tuning mode.
OX SEEK (Distance mode)
-7
SEEK (Local mode)
-7
OFF (Manual mode)
-7
OX SEEK
• The initial mode is Distance mode.
Distance mode:
Both strong and weak stations will be automatically tuned in
(Automatic Seek Tuning).
Local mode:
Only strong stations will be automatically tuned in (Automatic
Seek Tuning).
Manual mode:
The frequency is manually tuned in steps (Manual tuning).
4
Press
~
or
~
to tune in the desired station.
Holding down
~
or
~
will change the frequency
continuously.
Presetting Stations Manually
1
Select the radio band and tune in a desired radio
station you wish to store in the preset memory.
2
Press and hold, for at least 2 seconds, anyone of the
preset buttons (1 through 6) into which you wish
to store the station.
The selected station is stored.
The display shows the band, preset number and station
frequency memorized.
• A total of 18 stations can be stored in the preset memory (6 stations
for each band; FM I, FM2 and AM).
• If you store a station in a preset memory which already has a station,
the current station will be cleared and replaced with the new station.
7-EN