Sound Setting; Adjusting Subwoofer Levellbass Levelltreble Levellbalance (Between Left And Right)/Fader (Between Front And Rear)Ldefeat; Setting The Bass Control - Alpine CDE-103BT Owner's Manual

Sound Setting
SOURCE/<!> Rotary encoder (AUDIO/LOUD)
BAND
I
=
0 CJ
-~
liB
I
II (fl I)~
II
DO\l .,
.In@
i\ ~
) = (
//.
. .
.
. .
I
o../ESC SOUND/SETUP
Adjusting Subwoofer level/Bass level/
Treble level/Balance (Between left and
Right)/Fader (Between Front and Rear)/
Defeat
1
Press Rotary encoder (AUDIO) repeatedly to
choose the desired mode.
Each press changes the mode as follows:
SUBWOOFER* --; BASS LEVEL --; TRE LEVEL --; BALANCE
--; FADER --; DEFEAT --; VOLUME --; SUBWOOFER
Subwoofer : +0 - + 15
Bass level: -7 - +7
Treble level: -7 - +7
Balance: L15 - R15
Fader: R15 - F15
Defeat: ON/OFF
Volume. 0 - 35
• If
/10
operation is performed for 5 seconds after selecting the
SUBWOOFER, BASS LEVEL, TRE LEVEL, BALANCE, FADER or
DEFEAT mode, the unit autonwtically returns to normal mode.
*
When the subwoofer mode is set to OFF, its level cannot be adjusted.
2
Turn the Rotary encoder until the desired sound is
obtained in each mode.
By setting DEFEAT ON, previously adjusted settings of
BASS LEVEL and TRE LEVEL will return to the factory
defaults.
12-EN
Setting the Bass Control
You can change the Bass Frequency emphasis to create your own tonal
preference.
1
Press SOUND/SETUP repeatedly to select the
BASS mode.
BASS --; TREBLE --; HPF --; BASS
Setting the Bass Center Frequency
2-1
Press BAND to select the desired bass center
frequency.
80 Hz --; 100 Hz --; 200 Hz --; 60 Hz --; 80 Hz
Emphasizes the displayed bass frequency ranges.
Settiragtthe
Bass
[iJandwidth
2-2 Press SOURCE/<!> to select the desired bass
bandwidth.
UNa:rOW) :
~ ~ ~ ~--; (w~e)"]
Changes the boosted bass bandwidth to wide or narrow. A
wider setting will boost a wide range of frequencies above
and below the center frequency. A narrower setting will
boost only frequencies near the center frequency.
5ettingthe Bass Level
2-3*ITurn the Rotary encoder to select the desired
bass level (-7-+7).
You can emphasize or weaken the bass level.
3
Press and hold o../ESC for at least 2 seconds to
return to normal mode.
• If
no operation is performed for /5 seconds, the unit will return to
normal mode automatically.
• The bass level settings will be individuaLLy memorized for each
source (FM, AM, CD, etc.) until the setting is changed. The bass
frequency and bass bandwidth settings adjusted for one source are
effective for all other sources (FM, AM, CD, etc.).
• Thefunction is inoperable when DEFEAT is set to ON.
*1
The adjustment can also be made by pressing Rotnry encoder.
Refer
to
"Adjusting Subwoofer LevelJBass LevelJTreble LevelJ
Balance (Between Left and Right)/Fader (Between Front and Rear)/
Defeat" (page /2).