Blank Cover Plates - Alcatel OMNISWITCH 7000 Getting Started Manual

Note. The diagram below is a representation only; the
physical appearance of the actual MiniGBIC may vary.
GNI Module
MiniGBIC Slot
MiniGBIC Module
Caution. The MiniGBIC should slide in easily. Do not
force it into the slot. If any resistance is encountered,
ensure the MiniGBIC is aligned properly. Forcing the
MiniGBIC into the slot can damage the unit, as well as
components on your GNI module.
Note. To remove a MiniGBIC, you must first open the
MiniGBIC's hinged face to approximately ninety degrees.
Then, grasp the hinged face and carefully pull the
MiniGBIC straight out of the slot.
16 Installing the Hardware

Blank Cover Plates

Blank cover plates are factory-installed in the chassis and are
used to cover empty CMM and NI slots, as well as empty
power supply bays.
These cover plates play an important role in chassis airflow
and temperature management. They also provide protection for
module processor boards and other sensitive internal switch
components by closing off a chassis that is not fully populated.
Because they regulate airflow and help protect internal chassis
components, blank cover plates should remain installed at
empty module slots and power supply bays at all times.
March 2005