Aiming The Remote Control; Turning On Your Tv For The First Time - Dynex DX-26L100A13 User Manual

18
DX-26L100A13
2
Insert two AAA batteries into the battery
compartment. Make sure that you match the + and –
symbols on the batteries with the + and – symbols in
the battery compartment.
3
Replace the battery cover.
Remote Control 1
Remote Control 2
Cautions
• Batteries should not be exposed to excessive
heat, such as sunshine, heat registers, or fire.
• Battery chemicals can cause a rash. If the
batteries leak, clean the battery compartment
with a cloth. If chemicals touch your skin, wash
immediately.
• Make sure that batteries are disposed of
correctly. Do not burn or incinerate.
Notes
• Do not mix batteries of different types.
• Do not mix old and new batteries.
• Remove batteries when the charge is depleted.
• If the remote control is not going to be used for
an extended period of time, remove the
batteries.

Aiming the remote control

To aim the remote control:
• Point the remote control towards the remote sensor
on the front of your TV.

Turning on your TV for the first time

Turning on your TV for the first
time
The first time you turn on your TV, the Setup Wizard opens.
The Setup Wizard guides you through setting up basic
settings including the menu language, date and time,
picture mode, and TV signal source.
To set up your TV:
1
Make sure that you have:
• Installed the remote control batteries. (See
page 17 for details).
• Connected an antenna, cable TV, or satellite TV.
(See page 9 to page 11 for details.)
• Connected the power cord. (See page 9 for
details.)
2
Press (Power), then wait several seconds. The
Choose Your Menu Language screen opens.
Choose Your Menu Language
English
Français
Español
Move Select
Set menu language to English,Français,Español
3
Press or to highlight a language, then press
ENTER. The Choose Your Time Setting screen opens.
Choose your Time Setting
Mode
i T m e Z o n e
Daylight Savings Time
Year
Month
Day
Time
Move Select
If Automatic,options are automatically set by TV source
4
Press or to highlight Mode, then press
to select Custom (to set the date and time
manually), or Auto (to set the date and time
automatically from a TV signal source, based on the
time zone you select).
5
If you selected Auto for mode, press
highlight Time Zone, then press
your time zone. Choices include Eastern, Central,
Mountain, Pacific, Alaska, Hawaii, Atlantic, or
Newfoundland.
6
If you selected Auto for mode, press
highlight Daylight Savings Time, then press
to select On (if your viewing area observes Daylight
Savings Time), or Off (if your viewing area does not
observe Daylight Savings Time).
7
If you selected Custom for Mode, set the date by
pressing or to highlight Year, Month, or Day,
then press or
8
If you selected Custom for Mode, set the time by
pressing or to highlight Time, then press
to highlight the hour, minute, or AM/PM.
9
Press or to adjust the setting.
Setup Wizard
Next
Back Exit
MENU EXIT
Setup Wizard
Auto
a P i c c i f
2010
01
01
12 : 00 AM
Next
Back Exit
MENU EXIT
or to
or to select
or to
to change the setting.
or
or
or